close
Blogtrottr
批踢踢實業坊 PC_Shopping 板
 
[開箱] Thermaltake Core V31 機殼開箱
Feb 25th 2015, 20:48, by ang728

作者ang728 (要耍厨你還嫩的很)

看板PC_Shopping

標題[開箱] Thermaltake Core V31 機殼開箱

時間Wed Feb 25 20:48:07 2015

http://shadowsfalltw.gjisland.net/?p=3990 -- Core 系列最早是從上位,支援 EATX 的 V71 開始發表,然後是中塔 V51,另外還有一款 尚未在台灣販售的 Core V41 外觀規格則位於 V51、V31 之間;然後則是接下來則是這次 開箱的,外觀尺寸上較小的 V31,當然內部擴充性的支援也有些差異。另外還有專供 mATX 以及 ITX 機殼用的型號就不在這次的範圍之內。 產品外箱: http://shadowsfalltw.gjisland.net/pic/ttcorev31/corev31_01.JPG
節錄自官方的冷排支援以及規格諸元: http://shadowsfalltw.gjisland.net/pic/ttcorev31/support.JPG
http://shadowsfalltw.gjisland.net/pic/ttcorev31/v31spec.JPG
本體:具有透明側版。另外大量孔洞的前面板已經是 Core 系列機殼共通的特色。 http://shadowsfalltw.gjisland.net/pic/ttcorev31/corev31_02.JPG
前面板部分提供兩個 5.25”,其中一個可轉換成 3.5” 外接裝置;前面板IO 部分則是 僅提供兩個 USB 3.0、耳機、麥克風、電源、RESET與燈號。 http://shadowsfalltw.gjisland.net/pic/ttcorev31/corev31_03.JPG
http://shadowsfalltw.gjisland.net/pic/ttcorev31/corev31_04.JPG
面板內部:風扇開口完全沒有任何阻擋,螺絲固定孔也是可上下移動微調來配合冷排實裝 以後可能多占用的空間,但是前面板內並沒有濾網。 http://shadowsfalltw.gjisland.net/pic/ttcorev31/corev31_05.JPG
http://shadowsfalltw.gjisland.net/pic/ttcorev31/corev31_06.JPG
上方的 5.25” Drive Bay 也是可以拆除配合空間需要作調整,或者是用來安裝硬碟或 SSD。5.25 Drive Bay 可以透過內部的孔位安裝兩顆 2.5” 硬碟,或是一顆 3.5” 硬碟 而不需要俗稱小翅膀的延伸轉接架。 http://shadowsfalltw.gjisland.net/pic/ttcorev31/corev31_07.JPG
頂部全開孔:濾網為軟性材質並且邊緣具有磁性可吸附在外殼之上,方便拆洗。拔除濾網 之後可看到內部開孔為蜂巢狀,風扇螺絲孔位也同樣可移動微調,可支援140mm、120mm風 扇或是最大360冷排。 http://shadowsfalltw.gjisland.net/pic/ttcorev31/corev31_08.JPG
http://shadowsfalltw.gjisland.net/pic/ttcorev31/corev31_09.JPG
內部架構:內部可見大量模組化設計所需要的孔位,背面開孔與內部強度與目前相近價位 配置產品差不多,PCI檔版以及背部水管出入口周邊皆採開孔設計。後方出風風扇為12CM ,螺絲孔位也同樣非固定,可以上下微調位置。另外主機板安裝孔使用銅柱,並出廠時已 在ATX/MATX 共用孔位預先裝上所需銅柱。 http://shadowsfalltw.gjisland.net/pic/ttcorev31/corev31_10.JPG
http://shadowsfalltw.gjisland.net/pic/ttcorev31/corev31_11.JPG
http://shadowsfalltw.gjisland.net/pic/ttcorev31/corev31_12.JPG
http://shadowsfalltw.gjisland.net/pic/ttcorev31/corev31_13.JPG
硬碟架部分,Core 系列機殼都採模組化設計,V31配置一個可容納 3 顆 3.5 HDD 的硬碟 架,可以依照配置的要求來上下移動硬碟架位置,托盤部分也可透過底部的孔位來安裝 2.5” 硬碟,底層可以安裝兩顆 120mm 風扇,但要注意得將硬碟架底層的滑軌拆除,才 不會擋住風道。 http://shadowsfalltw.gjisland.net/pic/ttcorev31/corev31_14.JPG
http://shadowsfalltw.gjisland.net/pic/ttcorev31/corev31_15.JPG
http://shadowsfalltw.gjisland.net/pic/ttcorev31/corev31_16.JPG
http://shadowsfalltw.gjisland.net/pic/ttcorev31/corev31_17.JPG
http://shadowsfalltw.gjisland.net/pic/ttcorev31/corev31_18.JPG
下置電源的部分使用制震墊來防震,另外防塵濾網覆蓋面積也加大,以應付來自下方增加 風扇的不時之需,不過拆卸上就比較不方便些。 http://shadowsfalltw.gjisland.net/pic/ttcorev31/corev31_19.JPG
http://shadowsfalltw.gjisland.net/pic/ttcorev31/corev31_20.JPG
背面部分:主機板底板與硬碟架間以鉚釘固定,背部可擴增兩顆 2.5” 硬碟,當然也能 依配置來改變位置。走線孔的部分也相當充足。 http://shadowsfalltw.gjisland.net/pic/ttcorev31/corev31_21.JPG
http://shadowsfalltw.gjisland.net/pic/ttcorev31/corev31_22.JPG
http://shadowsfalltw.gjisland.net/pic/ttcorev31/corev31_23.JPG
http://shadowsfalltw.gjisland.net/pic/ttcorev31/corev31_24.JPG
配件一覽: http://shadowsfalltw.gjisland.net/pic/ttcorev31/corev31_25.JPG
試裝上機:因為僅配置1個硬碟架,所以空間算是相當夠,也有不少空間可以發揮走線創 意。散熱器部分使用了全高約在 15 CM 左右的 Venomous X 大概就是上限了。 http://shadowsfalltw.gjisland.net/pic/ttcorev31/corev31_26.JPG
http://shadowsfalltw.gjisland.net/pic/ttcorev31/corev31_27.JPG
http://shadowsfalltw.gjisland.net/pic/ttcorev31/corev31_30.JPG
背部一覽:走線與開孔大致上沒有太多問題,但是硬碟架背部的 SSD 架位置不算太優, 容易卡太多線材。另外 3.5” 硬碟區塊因為有多了固定的底板的緣故,即使已經有開孔 ,使用 L 頭 SATA 線材會有干涉,導致只能使用直頭 SATA 線材。 http://shadowsfalltw.gjisland.net/pic/ttcorev31/corev31_28.JPG
http://shadowsfalltw.gjisland.net/pic/ttcorev31/corev31_29.JPG
-- 模組化挺炫的,但是洞洞裝就看有沒有買單了 -- ※ 發信站: 批踢踢實業坊(ptt.cc), 來自: 111.242.188.249 ※ 文章網址: https://www.ptt.cc/bbs/PC_Shopping/M.1424868508.A.E57.html

This entry passed through the Full-Text RSS service - if this is your content and you're reading it on someone else's site, please read the FAQ at fivefilters.org/content-only/faq.php#publishers.

You are receiving this email because you subscribed to this feed at blogtrottr.com.

If you no longer wish to receive these emails, you can unsubscribe from this feed, or manage all your subscriptions
arrow
arrow
    全站熱搜

    nbv2x14xp1p6k 發表在 痞客邦 留言(0) 人氣()